Praactice Ammo

Bad Example: "CHEAPEST PRACTICE AMMO EVER FOR THE CHEAPEST PRACTICE EVER



(A Guest Post by blogless Peter, for Carnival of Cordite)



Let's face it, few of us can really afford to shoot enough to really get absolutely confident in our skill. It's not just the ammunition costs, either. Range time is expensive and with gas costs it's even expensive driving to the range. Then when we get there, we find there are all kinds of restrictions on how we can shoot. Some ranges don't allow rapid fire, most will go into hysterics if we try to work on a draw, and Lord help you if you need to practice engaging a threat from behind.



There is an answer, actually more than one. Primer powered wax, rubber and plastic bullets. Someone who is already a handloader is at least partially set up to use these handy little wonders. Someone who isn't will need some tools and some supplies. Some you have around the house already - a small hammer, a drill - some you'll have to buy, and there are other things that can speed the process up.



The first thing we need is modified cartridge cases. Unless you are already set up to handload, start with new, unprimed cases. Otherwise it's hard to find something that is thin enough to go through the factory flash hole yet strong enough to knock the spent primer out. Most outfits sell cartridge cases by the hundred. A little later on I'll tell you where to buy them and the priming tool you'll need.



The first thing we must do is drill the primer flash hole a little larger with a three-sixteenth inch drill bit. You'll need to hold the cartridge case with a pair of pliers and work the drill with the other hand...it's really a job for two people unless you have three hands. Hold the case as close to the rim as possible with those pliers, the metal is thicker down there and you won't be as likely to smoosh it and make it so it won't chamber. Whatever you do, do NOT omit this step. For technical reasons, a primer - fired with no powder behind a normal-weight bullet - will back out of the case and tie up a revolver. In an autoloader it might come completely out and get stuck in the works. Just trust me on this. I have the technical information and I'm not afraid to use it, it would only take about two pages to explain it." ETC ETC